 |
 |
|
|
|
|
| |
| Jared H. Shaffer |
|
 |
0 Comments |
|
1137 Views |
|
| Rating: |
|
 |
|
|
|
|
|
|
|
| |
|
| |
 |
|
| Posted |
In the process of using the gear motor to do micro gear motor maintenance of gear motor to make more efficient work, teach everyone below a few action let's look at the gear motor maintenance method. Check the installed base of gear motor, seal, shaft, etc.
When such as normal use, need to check the oil level of the lubricating oil () were observed by oil window, lubricating oil should be less than 85 ?, the highest temperature oil [litres of abnormal changes, the phenomenon such as abnormal noise, must stop the machine immediately to check, troubleshooting, may continue to use.
Work such as found in the abnormal situation it is necessary to stop the machine immediately to check, identify and troubleshoot rear can continue to work, often check the lubrication situation, pay attention to the complement of oil, and replace the metamorphism of lubricating oil in time, it is of great benefit for extended reduction motor using.
Gear motor in use process should be always kept clean, Small Geared Motors the surface shall not be piled up dirt so as not to affect the cooling, timely cleaning was carried out on the gear motor, gear box of gear case of machine cleaning maintenance using the original to the discharge of oil system and after filtering the old oil can be realized in the gear box, waste oil, cleaning rapid filtration, inject new oil, and other functions, process does not change the hardware facilities, do not add detergent, ensure the safety of the gear box operation, more greatly prolong the service life of gear motor.
Gear motor storage: should be stored in a dry and ventilated environment, when the storage period more than 3 months should make antirust processing, place the gear motor for about a year, before use to check whether the oil seal is aging, whether oil deterioration.
First is the micro gear speed reducer operating conditions: Small Dc Gear Motor the influence of different gear box will appear in the operation process of the gear oil overheating or generator overheating, lead to machine stop. Gear box for a long time work under the condition of high oil temperature of the work, it can aggravate the occurrence of pitting.
Micro pitting is a micro fatigue wear phenomenon, usually in sliding contact, elastic hydrodynamic lubrication performance of phenomena as gray surface in contact surface, which is a more uniform fatigue wear, while micro pitting is also the cause of gear box failure, micro pitting early general shallow spalling of tooth surface, polishing, slowly cause gray spots, occurrence of tooth surface, resulting in the gear failure, gear damage. |
|
|
|
|
| |
|
|
|
| |
|
|
